Mechanical Vapour Re-compression Evaporation Plants (MVRE Plants)

Mechanical vapour recompression manufacturers are the most effective means available for economizing energy consumption. Turbo Blowers or root blowers are used as mechanical vapour re-compressor, depending on the capacity of the compressors. Optima Heat Technologies offers stage or two-stage re-compression operation in our plants. This is done to minimize power consumption for the mechanical vapour compressor. Mechanical Vapour Recompression Manufacturers, thermal vapour recompression manufacturers

Salient Features

Lowest Operating Cost

Energy consumption is very low compared to steam-based Multiple effect evaporators
Single / Two-stage MVR designs for optimum Power consumption
Feed Pre-heaters are provided for better energy consumption.

Fully Electricity Driven

No Steam requirement for plant operation
Steam Boilers & related fuel handling equipment, pollution control systems are not required
Statutory inspection for Steam boilers avoided.

Low Maintenance

All heat exchangers are of Forced Circulation design.
Lowest chances of fouling
The plant can tolerate high-feed TDS and Hardness

Compact Design

Plant height is below 5.0 meters for most of the models.
No tall structure, tall building required.
Can be placed inside existing buildings
Supplied as SKID ready for operation

Simple Operation

Plant operation is completely automatic.
All flash vessels and heat exchangers are placed in the same level, so monitoring the plant is very easy.
Being low height design, no need for operator to run up & down few levels.

OptimaHeat Technologies also provide Mechanical Vapour Re-Compression Evaporation plants along with Centrifuge, ATFD etc., for powder separation.

Mechanical Vapour Re-compression Evaporation Plants (MVRE Plants)